#Laycock overdrive pars how to
#Laycock overdrive pars serial

jack stands (4) or ramps and 2 stands or lift if you are so lucky.

standard metric set 11mm to 18mm (sockets, wrenches, extensions, etc.).

The Speedometer seal need not be replaced unless it is leaking. *The two rings for the prv valve seat (22 & 23) need not be replaced if the seat is not easily removable (explanation later).

Two for the outside of solenoid ( 40 ) Thin.

O-Rings, listed from smallest to largest diameter: They are cross referenced to the part number ( ) on the OD diagram. The list of O-rings below is according to internal diameter and thickness.

Gasket between the OD unit housing and pan.

Gasket between OD unit and Rear trans housing.

Numbers that follow the description or are in the text are referenced to the accompanying diagram and may not coincide with the diagram the parts counter utilizes.

IPD sells a basic parts kit for this job. There is a complete list of all overdrive parts in the table below. Take in the whole number to your parts supplier.

#Laycock overdrive pars serial

The number begins with 27 then 115xxx and a serial number. To order the correct parts you will need the number off the unit that is on the right side of the unit. I suggest replacing all the following gaskets, seals and o-rings or ordering all as a preventive measure. Also use the accompanying diagram and text below to help in reassembly and keeping track of which O-ring goes where, (some are so close to the same size that size alone will not help you place them correctly). As preventive replace the 4th gear switch on the side of the trans. Going through the effort to R&R the OD then not having it work because of a broken/damaged/corroded wire, switch, or relay will destroy your day. I strongly suggest obtaining the Bentley Manual or the Volvo Service Manual as an assist in diagnosing and evaluating the OD unit.

#Laycock overdrive pars how to

This is only a compilation of tips that will make the job go smoother not a complete how to do it. This job should take 5 to 6 hours barring major problems without removing the transmission. If you can R & R the head you can do this. Text that follows assumes above average automotive repair knowledge. All rights to the diagram remain with Volvo. It is for reference only and could be superseded by the diagram at your local Volvo dealer. The accompanying overdrive (OD) parts and assembly Image.gif file is NOT intended to be the diagram that dictates your overdrive parts purchase and/or assembly. This information is intended for private use and convenience only. M-46 Overdrive Overhaul and O-Ring Repair and Replacement VOC Home | FAQ Home M46 Overdrive Rebuild